Lantronix SLC 8000 manual Rule Parameters, Ruleset Name, IP Addresses, Protocol

6: Basic Parameters

Figure 6-3 Network > IP Filter Ruleset (Adding/Editing Rulesets)

Rulesets can be added or updated on this page.

2. Enter the following:

Ruleset Name

Name that identifies a filter; may be composed of letters, numbers, and hyphens only. (The name cannot start with a hyphen.)

Example: FILTER-2

Rule Parameters

IP Address(es)	Specify a single IP address to act as a filter.
	Example: 172.19.220.64 – this specific IP address only
Subnet Mask	Specify a subnet mask to act determine how much of the address should apply to
	the filter.
	Example: 255.255.255.255 to specify the whole address should apply.
Protocol	From the drop-down list, select the type of protocol through which the filter will
	operate. The default setting is All.

SLC™ 8000 Advanced Console Manager User Guide 65