7: Services

 

 

 

 

CIFS User

Only one user special username (cifsuser) can access the CIFS share. Enter the CIFS

 

Password/Retype

user password in both password fields. The default user password is CIFSPASS.

 

Password

More than one user can access the share with the cifsuser user name and password

 

 

at the same time.

 

 

 

 

Workgroup

The Windows workgroup to which the SLC unit belongs. Every PC exporting a CIFS

 

 

share must belong to a workgroup. Can have up to 15 characters.

 

 

 

4.To save, click the Apply button.

5.Click the Firmware & Configurations link to access the

Firmware & Configurations (on page 227) to save SLC configuration, as desired.

NFS and SMB/CIFS Commands

The following CLI commands correspond to the web page entries described above.

To mount a remote NFS share:

set nfs mount <one or more parameters>

Parameters

locdir <Directory> mount <enabledisable> remdir <Remote NFS Directory> rw <enabledisable>

Enables read/write access to remote directory.

Note: The remdir and locdir parameters are required, but if you specified them previously, you do not need to provide them again.

To unmount a remote NFS share:

set nfs unmount <123>

To view NFS share settings:

show nfs

To configure the SMB/CIFS share, which contains the system and device port logs:

set cifs <one or more parameters>

Parameters

eth1 <enabledisable> eth2 <enabledisable> state <enabledisable> workgroup <Windows workgroup>

Note: The admin config command saves SLC configurations on the SMB/CIFS share.

To change the password for the SMB/CIFS share login (default is cifsuser):

set cifs password

SLC™ 8000 Advanced Console Manager User Guide

84

Page 84
Image 84
Lantronix SLC 8000 manual NFS and SMB/CIFS Commands, To mount a remote NFS share, To unmount a remote NFS share