5: Web and Command Line Interfaces

Note: The system administrator may have changed the password using one of the Quick Setup methods in the previous chapter.

To log in any other user:

1.Enter your SLC user name and press Enter.

2.Enter your SLC password and press Enter.

Logging Out

To log out of the SLC command line interface, type logout and press Enter.

Command Syntax

Commands have the following format:

<action> <category> <parameter(s)>

where

<action> is set, show, connect, admin, diag, or logout.

<category> is a group of related parameters whose settings you want to configure or view. Examples are ntp, deviceport, and network.

<parameter(s)> is one or more name-value pairs in one of the following formats:

<parameter name> <aabb>

User must specify one of the values (aa or bb) separated by a

 

vertical line ( ). The values are in all lowercase and must be

 

entered exactly as shown. Bold indicates a default value.

 

 

<parameter name> <Value>

User must specify an appropriate value, for example, an IP address.

 

The parameter values are in mixed case. Square brackets [ ]

 

indicate optional parameters.

 

 

Command Line Help

For general Help and to display the commands to which you have rights, type: help

For general command line Help, type: help command line

For more information about a specific command, type help followed by the command. For example: help set network or help admin firmware

Tips

Type enough characters to identify the action, category, or parameter name uniquely. For parameter values, type the entire value. For example, you can shorten:

set network port 1 state static ipaddr 122.3.10.1 mask 255.255.0.0 to

se net po 1 st static ip 122.3.10.1 ma 255.255.0.0

Use the Tab key to automatically complete action, category, or parameter names. Type a partial name and press Tab either to complete the name if only one is possible, or to display the possible names if more than one is possible. Following a space after the preceding name, Tab displays all possible names.

SLC™ 8000 Advanced Console Manager User Guide

54

Page 54
Image 54
Lantronix SLC 8000 manual Command Syntax, Command Line Help, Tips, To log in any other user