Lantronix SLC 8000 manual For general command line Help, type

	14: Command Reference
Action	Category
(continued)
diag	arpinternalslookuploopbacknetstatnettraceperfstatping
	ping6sendpackettoptraceroute
admin	bannerclearconfigeventsfirmwareftpkeypadlcdmemory
	quicksetuprebootshutdownsiteversionweb
logout	Terminates CLI session.

Command Line Help

For general Help and to display the commands to which you have rights, type:

help

For general command line Help, type:

help command line

For more information about a specific command, type help followed by the command, for example:

help set network or help admin firmware

Tips

Type enough characters to identify the action, category, or parameter name uniquely. For parameter values, type the entire value. For example, you can shorten:

set network port 1 state static ipaddr 122.3.10.1 mask 255.255.0.0 to

se net po 1 st static ip 122.3.10.1 ma 255.255.0.0

Use the Tab key to automatically complete action, category, or parameter names. Type a partial name and press Tab either to complete the name if only one is possible, or to display the possible names if more than one is possible. Following a space after the preceding name, Tab displays all possible names.

Should you make a mistake while typing, backspace by pressing the Backspace key and/or the Delete key, depending on how you accessed the interface. Both keys work if you use VT100 emulation in your terminal access program when connecting to the console port. Use the left and right arrow keys to move within a command.

Use the up and down arrows to scroll through previously entered commands. If desired, select one and edit it. You can scroll through up to 100 previous commands entered in the session.

To clear an IP address, type 0.0.0.0, or to clear a non-IP address value, type CLEAR.

When the number of lines displayed by a command exceeds the size of the window (the default is 25), the command output is halted until the user is ready to continue. To display the next line, press Enter, and to display the page, press the space bar. You can override the number of lines (or disable the feature altogether) with the set cli command.

SLC™ 8000 Advanced Console Manager User Guide 261