Lantronix SLC 8000 manual Internal Temperature, Site Information, SLC Firmware

	12: Maintenance
2. Enter the following:
Reboot	Select this option to reboot the SLC 8000 advanced console manager
	immediately. The default is No.
	Note: The front panel LCD displays the “Rebooting the SLC” message, and the
	normal boot sequence occurs.
Shutdown	Select this option to shut down the SLC unit. The default is No.
Internal Temperature
Current	Displays current temperature.
Low (°C)	Sets the acceptable minimum for the internal temperature of the SLC 8000
	advanced console manager. If the temperature of the SLC device changes to be
	outside of this range, the SLC console manager will issue an SNMP trap.
High (°C)	Sets the acceptable maximum for the internal temperature of the SLC unit. If the
	temperature of the SLC 8000 advanced console manager changes to be outside
	of this range, the SLC unit will issue an SNMP trap.
Calibrate Offset (°C)	An offset for calibrating the internal temperature of the SLC console manager. The
	offset will be applied one hour after setting the calibration value. Zeroing the
	offset will take effect immediately and will cancel any current and/or pending
	calibration.
Site Information
Data Center Rack Row	Set these fields to define the rack row the SLC unit is located within a large data
	center. The default for these fields is 1.
Data Center Rack	Set these fields to define the rack cluster the SLC 8000 advanced console
Cluster	manager is located within a large data center. The default for these fields is 1.
Data Center Rack	Set these fields to define the rack the SLC unit is located within a large data
	center. The default for these fields is 1.

SLC Firmware

Note: The non-active boot bank is updated during the firmware update, without requiring a reboot. The configuration on the current boot bank may optionally be copied to the non- active boot bank during the firmware update.

Current Version	Displays the current firmware version.
Update Firmware	 To update the SLC firmware, select the checkbox. If you select this option, the
	SLC unit reboots after you apply the update. The first time boot for each bank
	may take up to 5 minutes. Subsequent boot times will be approximately 2
	minutes.
	 To view a log of all prior firmware updates, click the Firmware Update Log
	link.
Firmware Filename	The name of the firmware update file downloaded from the Lantronix web site.
Key	A key for validating the firmware file. The key is provided with the firmware file
	(32 hex characters).

SLC™ 8000 Advanced Console Manager User Guide 229