Lantronix SLC 8000 manual Hardware Signal Triggers, Modem Settings Device Ports

	8: Device Ports
Show Lines on	If enabled, when the user either does a connect direct from the CLI or connects
Connecting	directly to the port using Telnet or SSH, the SLC outputs up to 24 lines of buffered
	data as soon as the serial port is connected.
	For example, an SLC user issues a connect direct device 1 command
	to connect port 1 to a Linux server.
	Then the SLC user ls command to display a directory on the Linux server, then
	exits the connection. When the SLC user issues another direct connect
	device 1, the last 24 lines of the ls command is displayed so the user can see
	what state the server was left in.
Reverse Pinout	If enabled, swaps the positions of the serial lines, such that the direction of data or
	the signal is reversed. For instance, TX is swapped with RX. Enabling Reverse
	Pinout facilitates connections to Cisco and Sun style RS-45 console ports using a
	straight through Ethernet patch cable, without the need for a rolled cable or
	adapter. Enabled by default.
	Note: All Lantronix serial adapters are intended to be used with Reverse Pinout
	disabled. If you are replacing an original SLC unit with an SLC 8000 advanced
	console manager, disable the reverse pinout so you can use the original cables
	and adapters.
Hardware Signal Triggers
Check DSR on	If this setting is enabled, the device port only establishes a connection if DSR
Connect	(Data Set Ready) is in an asserted state. DSR should already be in an asserted
	state, not transitioning to, when a connection attempt is made. Disabled by default
	unless dial-in, dial-out, or dial-back is enabled for the device port.
Disconnect on DSR	If a connection to a device port is currently in session, and the DSR signal
	transitions to a de-asserted state, the connection disconnects immediately.
	Disabled is the default unless dial-in, dial-out, or dial-back is enabled for the device
	port.

Modem Settings (Device Ports)

Note: Depending on the State and Mode you select, different fields are available.

State	Used if an external modem is attached to the device port. If enabling, set the
	modem to dial-out, dial-in, dial-back, dial-on-demand, dial-in/host list, dial-back &
	dial-on-demand, dial in & dial-on-demand, CBCP Server, and CBCP Client.
	Disabled by default. See Modem Dialing States (on page 152) for more
	information.
Mode	The format in which the data flows back and forth:
	 Text: In this mode, the SLC advanced console manager assumes that the
	modem will be used for remotely logging into the command line. Text mode
	can only be used for dialing in or dialing back. Text is the default.
	 PPP: This mode establishes an IP-based link over the modem. PPP
	connections can be used in dial-out mode (e.g., the SLC unit connects to an
	external network), dial-in mode (e.g., the external computer connects to the
	network that the SLC 8000 advanced console manager is part of), or dial-on-
	demand.
Use Sites	Enables the use of site-oriented modem parameters which can be activated by
	various modem-related events (authentication, outbound network traffic for dial-
	on-demand connections, etc.). Sites can be used with the following modem
	states: dial-in, dial-back, dial-on-demand, dial-in & dial-on-demand, dial-back &
	dial-on-demand, and CBCP server.

SLC™ 8000 Advanced Console Manager User Guide 109