Lantronix SLC 8000 manual Certificate in base64 encoding, Key File is in PEM format, eg

	11: User Authentication
Certificate Authority	A certificate can be uploaded to the SLC unit for peer authentication. If a certificate
	is uploaded, all 3 files are required. The Certificate Authority and Certificate File are
Certificate File
	in PEM format, eg:
Key File	-----BEGIN CERTIFICATE-----
	(certificate in base64 encoding)
	-----END CERTIFICATE-----
	The Key File is in PEM format, eg:
	-----BEGIN RSA PRIVATE KEY-----
	(private key in base64 encoding)
	-----END RSA PRIVATE KEY-----
Custom Menu	If custom menus have been created, you can assign a default custom menu to
	LDAP users. (See “Custom Menus” on page 220.)
Escape Sequence	A single character or a two-character sequence that causes the SLC 8000
	advanced console manager to leave direct (interactive) mode. (To leave listen
	mode, press any key.)
	A suggested value is Esc+A (escape key, then uppercase "A" performed quickly
	but not simultaneously). You would specify this value as \x1bA, which is
	hexadecimal (\x) character 27 (1B) followed by an A.
	This setting allows the user to terminate the connect direct command on the
	command line interface when the endpoint of the command is deviceport, tcp, or
	udp.
Break Sequence	A series of 1-10 characters users can enter on the command line interface to send
	a break signal to the external device. A suggested value is Esc+B (escape key,
	then uppercase “B” performed quickly but not simultaneously). You would specify
	this value as \x1bB, which is hexadecimal (\x) character 27 (1B) followed by a B.
Enable for Dial-back	Select to grant a user dial-back access. Users with dial-back access can dial into
	the SLC unit and enter their login and password. Once the SLC 8000 advanced
	console manager authenticates them, the modem hangs up and dials them back.
	Disabled by default.
Dial-back Number	The phone number the modem dials back on depends on this setting for the device
	port. The user is either dialed back on a fixed number, or on a number that is
	associated with the user’s login (specified here).
Data Ports	The ports users are able to monitor and interact with using the connect
	direct command. U1 and U2 denote the USB upper and lower ports on the front
	of the SLC unit.
Listen Ports	The ports users are able to monitor using the connect listen command.
Clear Port Buffers	The ports whose port buffer users may clear using the set locallog clear
	command.

3. In the User Rights section, select the user group to which LDAP users will belong:

Group

Select the group to which the LDAP users will belong:

Default Users: This group has only the most basic rights. You can specify additional rights for the individual user.

Power Users: This group has the same rights as Default Users plus Web Access, Networking, Date/Time, Reboot & Shutdown, and Diagnostics & Reports.

Administrators: This group has all possible rights.

SLC™ 8000 Advanced Console Manager User Guide 193