Lantronix SLC 8000 Enable for Dial-back, Custom Menu, Display Menu at Login, Password Expires

	11: User Authentication
Enable for Dial-back	Select to grant a local user dial-back access. Users with dial-back access can
	dial into the SLC unit and enter their login and password. Once the SLC 8000
	advanced console manager authenticates them, the modem hangs up and
	dials them back. Disabled by default.
Dial-back Number	The phone number the modem dials back on depends on this setting for the
	device port. The user is either dialed back on a fixed number (specified on the
	Device Port - Settings page), or on a number that is associated with the user’s
	login (specified here).
Escape Sequence	A single character or a two-character sequence that causes the SLC unit to
	leave direct (interactive) mode. (To leave listen mode, press any key.)
	A suggested value is Esc+A (escape key, then uppercase "A" performed
	quickly but not simultaneously). You would specify this value as \x1bA, which
	is hexadecimal (\x) character 27 (1B) followed by an A.
	This setting allows the user to terminate the connect direct command on
	the command line interface when the endpoint of the command is deviceport,
	tcp, or udp.
Break Sequence	A series of 1-10 characters users can enter on the command line interface to
	send a break signal to the external device. A suggested value is Esc+B
	(escape key, then uppercase “B” performed quickly but not simultaneously).
	You would specify this value as \x1bB, which is hexadecimal (\x) character 27
	(1B) followed by a B.
Custom Menu	If custom menus have been created, you can assign a default custom menu to
	the user. The custom menu will display at login.
	Note: In the Local Users table, if the menu assigned to a local user no longer
	exists, it is marked with an asterisk (*).
Display Menu at Login	If custom menus have been created, select to enable the menu to display
	when the user logs into the CLI.
Password /	When a user logs into the SLC 8000 advanced console manager, the SLC unit
Retype Password	prompts for a password (up to 64 characters). The sysadmin establishes that
	password here.
Password Expires	If not selected, allows the user to keep a password indefinitely. If selected the
	user keeps the password for a set period. (See the section, Local and Remote
	User Settings (on page 178) for information on specifying the length of time
	before the password expires.)
Allow Password Change	Select to allow the user to change password.
Change Password on	Indicate whether the user must change the password at the next login.
Next Login
Lock Account	Select to lock the account indefinitely.
Account Status	Displays the current account status:
	 Active
	 Locked
	 Locked (invalid logins)

SLC™ 8000 Advanced Console Manager User Guide 181