Lantronix SLC 8000 manual To rename a saved configuration, To delete a saved configuration

12: Maintenance

To restore a saved configuration to the SLC 8000 advanced console manager:

admin config restore <Config Name> location <localftpsftpnfscifsusbsdcard> [nfsdir <NFS Mounted Dir>] [usbport <U1U2>] [savescripts<enabledisable>] [savesshkeys <enabledisable>] [savesslcert <enabledisable>] [preserveconfig <Config Params to Prserve>]

<Config Params to Preserve> is a comma-separated list of current configuration parameters to retain after the config restore or factory defaults:

nt – Networking		lu	–	Local Users
sv –	Services	dp	–	Device Ports
dt –	Date/Time	ub	–	USB Port/SD	Card

To save the current SLC configuration to a selected location:

admin config save <Config Name> location <localftpsftpnfscifsusbsdcard> [nfsdir <NFS Mounted Dir>] [usbport <U1U2>]

To rename a saved configuration:

admin config rename <Config Name> location <localnfscifsusbsdcard> [nfsdir <NFS Mounted Dir>] [usbport <U1U2>]

To delete a saved configuration:

admin config delete <Config Name> location <localnfscifsusbsdcard> [usbport <U1U2>]

To list the configurations saved to a location:

admin config show <localftpsftpnfscifsusbsdcard> [nfsdir <NFS Mounted Dir>] [usbport <U1U2>]

To set the acceptable range for the internal temperature sensor (an SNMP trap is sent if the temperature is outside of this range):

set temperature <one or more parameters>

Parameters

low <Low Temperature in C. or F.> high <High Temperature in C. or F.>

calibrate <Temperature Calibration in C. or F.cancel>

Note: The calibration offset will be applied one hour after setting the value.

To display the acceptable range and current reading from the internal temperature sensor:

show temperature

SLC™ 8000 Advanced Console Manager User Guide 234