Lantronix SLC 8000 manual Config Eth1, IP Address if, Specifying

4: Quick Setup

Figure 4-8 Beginning of Quick Setup Script

Quick Setup will now step you through configuring a few basic settings.

The current settings are shown in brackets ('[]').

You can accept the current setting for each question by pressing <return>.

4. Enter the following information at the prompts:

Note: To accept a default or to skip an entry that is not required, press Enter.

CLI Quick Setup	Description
Settings
Config Eth1	Select one of the following:
	 (1) obtain IP Address from DHCP: The unit will acquire the IP address, subnet
	mask, hostname, and gateway from the DHCP server. (The DHCP server may or
	may not provide the gateway and hostname, depending on its setup.) This is the
	default setting.
	 (2) obtain IP Address from BOOTP: Permits a network node to request
	configuration information from a BOOTP "server" node.
	 (3) static IP Address: Allows you to assign a static IP address manually. The IP
	address is generally provided by the system administrator.
IP Address (if	An IP address that is unique and valid on your network and in the same subnet as
specifying)	your PC. There is no default.
	If you selected DHCP or BOOTP, this prompt does not display.
	Enter all IP addresses in dot-quad notation. Do not use leading zeros in the fields for
	dot-quad numbers less than 100. For example, if your IP address is 172.19.201.28,
	do not enter 028 for the last segment.
	Note: Configurations with the same IP subnet on multiple interfaces (Ethernet or
	PPP) are not currently supported.
Subnet Mask	The subnet mask specifies the network segment on which the SLC 8000 advanced
	console manager resides. There is no default. If you selected DHCP or BOOTP, this
	prompt does not display.
Default Gateway	IP address of the router for this network. There is no default.
Hostname	The default host name is slc, where XXXX is the last 4 characters of the hardware
	address of Ethernet Port 1. There is a 64-character limit (contiguous characters, no
	spaces).
	Note: The host name becomes the prompt in the command line interface.
Domain	If desired, specify a domain name (for example, support.lantronix.com). The domain
	name is used for host name resolution within the SLC unit. For example, if abcd is
	specified for the SMTP server, and mydomain.com is specified for the domain, if
	abcd cannot be resolved, the SLC 8000 advanced console manager attempts to
	resolve abcd.mydomain.com for the SMTP server.
Time Zone	If the time zone displayed is incorrect, enter the correct time zone and press Enter. If
	the entry is not a valid time zone, the system guides you through selecting a time
	zone. A list of valid regions and countries displays. At the prompts, enter the correct
	region and country.

SLC™ 8000 Advanced Console Manager User Guide 47