4069-XXX
| FRU | Action |
|
|
|
4 | Smart Cartridge Cable | Check the voltage on the smart |
| Engine Board | cartridge contact. The voltage |
|
| measures approximately +5 V dc |
|
| when not writing data to the engine |
|
| board. If data is being written, the |
|
| voltage measures approximately |
|
| +12 V dc. If incorrect, disconnect the |
|
| cable from J21 on the engine board |
|
| and check the voltage on |
|
| voltage measures approximately |
|
| +5 V dc. If incorrect, replace the |
|
| engine board. If correct, replace the |
|
| smart cartridge cable. |
|
|
|
Serial Port Service Check
Run the “Serial Wrap Test” on page
Note: The Serial Wrap Test is designed to check the serial port hardware by using a wrap plug (P/N 1329048) and invoking the Serial Post Diagnostic Test. The test helps isolate the printer from the serial cable and host. The test provides failure information on the display for approximately three seconds. If the test indicates a problem, replace the controller board.
Toner Sensor Service Check
Service Tip: Check the print darkness MENU setting before checking the toner sensor.
This service check is intended to be used when a 929 Service Error displays.
| FRU | Action |
|
|
|
1 | Developer Drive Assembly | Incorrect operation of the developer |
|
| drive assembly can cause the printer |
|
| to display a 929 error code (Toner |
|
| Sensor). Check the developer drive |
|
| assembly for correct installation, any |
|
| sign of worn, loose or broken parts. |
|
|
|
