The base printer indicates a dead machine condition when the high capacity input tray is installed.
| FRU | Action |
|
|
|
1 | AC Line Cord | If the base printer works normally |
| AC Jumper (HCIT to | using the AC line cord from the AC |
| Printer) | wall outlet and does not work when |
| AC input and Output | using the AC jumper from the HCIT, |
| Receptacles | check the AC jumper cord. If |
| AC Wiring Harness | defective, replace the cord. If not |
|
| defective, check the AC input and |
|
| output receptacles and wiring |
|
| harness in the HCIT. Repair or |
|
| replace the receptacles or AC wiring |
|
| harness as required. |
|
| NOTE: Make sure the ground wire is |
|
| installed correctly from the AC wiring |
|
| harness to the frame of the HCIT |
|
| and the nut and lockwasher are |
|
| tightened down. |
|
|
|
