Lexmark 4069-XXX manual Paper Jam Check Bin X. Post Incomplete

4069-XXX

Remove Paper - Output Bin X is displayed, POST Incomplete, Unable to clear the message.

	FRU	Action
1	Dual Output Bin Sensor Flag	Check the flag for correct
		operation, binding, broken parts or
		interference from the sensor
		cable, If incorrect, repair as
		necessary.
271 Paper Jam - Check Bin X. POST Incomplete

	FRU	Action
1	Pass Thru Sensor and Flag	Check the sensor flag for proper
	Assembly	operation. If correct, check to
	Control Board	make sure the pass thru sensor
		cable is correctly connected to J3
		on the control board. Disconnect
		the pass thru sensor cable from J3
		on the control board and check
		the voltage at J3-3. The voltage
		measures approximately +5 V dc.
		If incorrect, replace the control
		board. If correct, check the voltage
		at J3-2. The voltage measures
		approximately 0 V dc. If incorrect,
		replace the sensor assembly. If
		this does not fix the problem,
		replace the control board.

271 Paper Jam - Check Bin X, POST Complete, First Sheet of paper feeds into Output Bin X.

Note: Before performing the following checks run the Output Bin X Sensor Test and check for the failing sensor.

Sensor Test: NF = Near Full (Upper part of sensor assembly) F = Full (Lower Part of sensor assembly)

P = Pass Thru Sensor

Diagnostic Information 2-77