Lexmark 4069-XXX manual High-Capacity Output Stacker Service Check

4069-XXX

No indication that Bin X is Full OR No indication that Bin X is Near Full

	FRU	Action
1	Dual Output Bin X Sensor	Check for correct installation of
	Assembly	the sensor cable at J5 on the
	Control Board	control board. If either the Bin Full
		(F) or Bin Near Full (NF) fail the
		sensor test then check the voltage
		at J5-3 and J5-4. The voltage
		measures approximately +5 V dc.
		If the voltage is incorrect, replace
		the control board. If correct,
		replace the sensor assembly.

High-Capacity Output Stacker Service Check

Service Tip: The majority of the mechanical components can be observed during operation by removing the left, right and front covers. The high capacity output stacker option functions without the covers installed.

Models 010 and 010n do not support this output option.

Determine which paper path stacker assembly is not functioning properly.

Make sure the option(s) are installed correctly and the machine is configured correctly before attempting to service the high-capacity output stacker option.

Go to “High-Capacity Output Stacker Board” on page 5-22 to identify the correct jumper location at J6 for the upper and lower units.

Diagnostic Information 2-79