4069-XXX
validate the Configuration ID. If the ID is invalid then "INVALID ID" message displays on Line 2 before the ID redisplays. You have to reenter the Configuration ID until a valid ID is verified. If the ID is valid then the ID is saved in NVRAM and the printer automatically PORs to activate the new setting.
Note: When the printer PORs it does so in the normal mode.
Restore EP Factory Defaults
To restore each of the printer settings contained in the EP Setup menu to their factory default value select Restore from the menu. To exit the menu without restoring the settings to the factory default values, select Do Not Restore. Sometimes this is used to help correct print quality problems.
Fuser Temperature
This adjustment can be used to help solve some customer problems with paper curl on low grade papers and or problems with letter heads on some types of media.
The fuser temperature can be adjusted as follows:
•NORMAL
•LOWER
•LOWEST
Warm Up Time
You can change the amount of time the printer warms up before allowing pages to print by changing this setting from 0 to 5. The factory sets the warm up at 0 or no warm up time. This time period allows the backup roll to heat up and helps reduce curl in some environments.
Transfer
The transfer can be adjusted as follows:
•LOW
•MEDIUM
•HIGH
