Lexmark 4069-XXX manual Envelope Feeder Option Service Check

4069-XXX

Envelope Feeder Option Service Check

Service Tip: Check the envelope feeder paper path for any debris, pieces of envelope and so on. If any other options are installed make sure they are operating normally. If only the envelope feeder is failing to operate correctly, continue with this service check, otherwise go to the Interconnect Card Service Check.

Service Tip: The envelope feeder option receives its +5 V dc operating voltage from the +24 V dc bulk at J1-7. If +24 V dc is not present at J1-7, tray 1 is the only tray option that is recognized.

Note: If a 260 Paper Jam Check Envelope message displays, check the “Sub Error Codes For 9XX and 2XX Error Codes” on page 2-8.

Printer does not recognize the envelope feeder as an attached input option.

	FRU	Action
1	Envelope Feeder	Check to make sure the envelope
		feeder is correctly installed and
		mated to the autoconnect at the front
		of the printer.
2	Front Autoconnect on	Check the connector for signs of
	Printer	damage to the connector or
		contacts. If you find damage, replace
		the damaged cable/connector
		assembly. Remove the envelope
		feeder option and check the voltages
		at the autoconnect on the front of the
		printer. If incorrect, check the
		interconnect board. If correct,
		reinstall the envelope option and
		continue with step 3.

2-38Service Manual