4069-XXX
If the high capacity output stacker is selected then the following is displayed:
HC BIN 1
TP=OP, P=OP, F=OP, NF=OP
IP = high capacity output stacker top position sensor
P = high capacity output stacker passthru sensor
F = high capacity output stacker full sensor
NF = high capacity output stacker near full sensor
If the
<output bin> (output bin displayed on line 1 = output bin 1, output bin2, output bin3, output bin4 or output bin 5 for the bin selector)
P1 =
P2 =
L = NL, bin contains media but the bin is not near full on full L = NF, indicates bin is near full
L = FL, indicates bin is full
Base Sensor Test
This test is used to determine if the sensors located inside the printer are working correctly.
The following sensors can be checked:
Toner Optical Sensor
Input Sensor
Output Sensor (Fuser Exit)
Narrow Media Sensor
Front Door Sensor (Upper Front Cover)
To run the Base Sensor Test:
1.Select the Base Sensor Test.
–The operator panel displays OP for open and CL for closed.
2.Manually toggle the sensors by hand to verify that each sensor switches from open to closed.
Diagnostic Aids
