SCSI Description
5-42 Maxtor Atlas 10K III
Table 5-53 lists the mode pages that are supported by the drive. An initiator can
change these pages by supplying them, with the desired changes included, in the
MODE SELECT command’s data-out buffer transfer.
The initiator should first use a MODE SENSE command to read the appropriate pages
and leave non-changeable values as read when the initiator subsequently writes the
changeable pages with the MODE SELECT command. If a non-changeable field
co n tain s an in va lid value, th e d riv e re tu rn s a CH ECK COND IT ION s tatus .
Initiator-Change able Mode Page s
NOTES:
1. This page is not supported by the SCSI-1/CCS Operating Mode.
2. The Notch and Partition page is changeable but NOT savable.
3. XOR is currently disabled and page is not changeable.
00h Unit Att enti on Control Page Unit Attention report-
ing (enables or dis -
ables) 4
01h Read-Write Error Recovery Page
Medium Access Error
recovery and report-
ing procedure s for
READ and WRITE
commands
12
02h Disconnect-Reconnect Page Bus behavior during
data transfers 16
07h1Verify Error Recovery Page
Medium Access Error
recovery and report-
ing procedures for the
VERIFY command
12
08h1Caching Page Cache po li cy 20
0Ah1Control Mode Page Command processing
policy 12
0Ch Notch and Partiti on Page2Drive geometry re-
porting 24
10h XOR Control Page Contr ols XOR ope rat-
ing parameters 24
19h Port Control Page Defines por t control
parameters 8
1Ah Power Condition Page Enable and set time
in ter val s for Idl e a nd
Standby modes 12
1Ch1
Information Exceptions Control
Page an d operations of specific
inform ational exception condi-
tions.
Defines methods to
control reporting 12
39h Maxtor-Unique Page 22