Installation

￿￿￿￿￿*#4&9#4'%QPHKIWTCVKQPThis section￿includes126+105￿,WORGTUsetup￿CPFand￿configuration%QPPGEVKQPUinformation￿ for Maxtor Atlas 10K III drives. These disk drives include

The 16-bit multimode Ultra160 SCSI, wide version with 68-pin SCSI connector,

The 16-bit multimode Ultra160 SCSI, version with SCA-2 80-pin connector.

The 16-bit multimode Ultra320 SCSI, wide version with 68-pin SCSI connector,

The 16-bit multimode Ultra320 SCSI, version with SCA-2 80-pin connector.

Specific individual settings for each drive type are described in Sections 3.5.1 through 3. . .

 

 

 

Before you begin, review the Safety, ESD, and Handling precau

-

 

 

 

tions described at the beginning of this manual to avoid personal

in-

 

 

 

jury or damage to equipment.

 

 

 

 

￿￿￿￿￿

,WORGTThis section￿1RVKQPUdescribes￿QP￿VJGhow￿￿￿￿to configure2KP￿9KFGthe￿2%jumpers$￿on Maxtor Atlas 10K III disks

 

with 68-pin SCSI interface connectors. The following features are jumper-

 

selectable:

 

• A0, A1, A2, A3 – SCSI Bus Device Identification

 

FO – Fault Out (Remote LED)

 

DS – Delay Spin

 

• SE – Force SE (Single-Ended, Disable LVD)

 

BO – Busy Out (Remote LED)

 

WP – Write Protect

 

• SS – Stagger Spin

 

%#76+10￿

 

 

 

NW – No Wide (Enable Narrow Mode)

 

TERMPWR – Termination Power

Note: The disk drive does not support on-board SCSI termination.

3-6 Maxtor Atlas 10K III

Page 32
Image 32
Maxtor 10K III manual #76+10