Maxtor 10K III manual Supported Sense Keys

		SCSI Description
		Supported Sense Keys
		There is no specific sense key information to be reported for the designated
5GPUGNO SENSE￿-G[	%QFG0h	logical unit. This is the case for &GUETKRVKQPa successful command or a command that
		received CHECK CONDITION or COMMAND TERMINATED status because
		one of the following bits is set to 1: File Mark, EOM, or ILI.
		The last command completed successfully with some recovery action per-
RECOV-		formed by the drive. Details may be contained in the additional sense bytes
	1h	and the Information field. When multiple recovered errors occur during one
EREDERROR
		command, the choice of which error to report (first, last, most severe, etc.)
		is device specific.
NOT READY	2h	The logical unit cannot be accessed. Operator intervention may be required
		to correct this condition.
		The command terminated with a non-recovered error condition that was
MEDIUM	3h	probably caused by a flaw in the medium or an error in the recorded data.
ERROR		This sense key can also be returned if the drive is unable to distinguish be-
		tween flaw in the medium and a specific hardware failure (Sense Key
HARDWARE		The drive detected a non-recoverable hardware failure while performing the
	4h	command or during a self-test. The error type could be controller failure, de-
ERROR
		vice failure, etc.
		The drive detected an illegal parameter in the Command Descriptor Block or
		in the additional parameters supplied as data for some commands. If the
ILLEGAL		drive detects an invalid parameter in the Command Descriptor Block, it ter-
	5h	minates the program without altering the medium. If the drive detects an
REQUEST		invalidTableparameter5-176in the additional parameters supplied as data, the drive
		may have already altered the medium. This sense key may also indicate that
		an invalid IDENTITY message was received.
		The drive generates this sense key whenever the drive is reset by a TARGET
		RESET message, a hard reset condition, or by a power-on reset. Other con-
		ditions that generate a UNIT ATTENTION include:
		The mode parameters in effect for this initiator have been changed by an-
		•
		other initiator.
UNIT		The microcode has been changed.
ATTENTION	6h	Tagged commands queued for this initiator were cleared by another initi-
		ator.
		INQUIRY data has been changed.
		The mode parameters in effect for the initiator have been restored from
		non-volatile memory.
		Other events that require the attention of the initiator.
DATA	7h	A Read or Write command was attempted on a sector that is protected for
PROTECT		this operation. The requested operation was not performed.
VENDOR	9h	This sense key is used to report specific Maxtor conditions.
SPECIFIC
ABORTED	Bh	The drive aborted the command. The initiator may be able to reissue the
COMMAND		command successfully.
MISCOM-	Eh	The source data did not match the data read from the medium (i.e., a mis-
PARE		match).

Maxtor Atlas 10K III 5-137