SCSI Description

 

RELEASE (10) Command — Field Descriptions

 

 

 

 

 

Third Party Release allows an initiator to release a logical unit that was previously

 

reserved. If the value in this field is 0, third party release is not requested. If 3rdPty

3rdPty(KGNF

= 1, then the device server will release&GUETKRVKQPthe specified logical unit, but only if the ini-

 

tiator ID, 3rdPty bit, and third party device ID are identical when compared to the

 

RESERVE command that established the reservation.

 

 

 

 

If the Long ID bit is set to 1, the Parameter List Length is 8 and the eight bytes of

LongID

the parameter list carry the device ID of the third party device; the contents of the

 

Third Party Device ID in the CDB (byte 3) are ignored.

 

 

 

 

If the Third Party Device ID value that is connected with the reservation release is

 

smaller than 255, the LongID bit may be 0 and the ID value sent in the CDB. If

 

LongID bit = 0, the Parameter List Length field also = 0. If the Third Party Device

Third Party De-

ID value is greater than 255, LongID = 1.

 

vice ID

Device servers that support device IDs greater than 255 will accept commands with

 

 

LongID = 1; device servers that do not support IDs greater than 255 may reject

 

commands with LongID set = 1. Device ID formats are protocol-specific.

 

 

Parameter List

The contents of this field specify the length, in bytes, of the parameter list that will

Length

be transferred from the initiator to the target.

 

 

 

 

Extent

The drive supports reservations only on entire logical units.

 

 

 

 

Reservation

Any value in this field is ignored by the drive.

6JG￿XCNWG￿OWUV￿DG￿￿￿

Identification

Table5-164

 

Assuming that the RELEASE Command Descriptor Block is valid, the drive Note:always returns a GOOD status for this command. An actual release only hap-

pens if the initiator has the unit reserved for itself or a third-party initiator.

5-128 Maxtor Atlas 10K III

Page 192
Image 192
Maxtor 10K III manual 164, Release 10 Command Field Descriptions