Maxtor 10K III manual Recovery, Cases where error recovery is invoked and successful

			SCSI Description
		Read Continuous. When the value is 0, the drive attempts error recovery
RC	0	when it encounters an error. When the value is 1, the drive suppresses error
		recovery.
EER	0	Enable Early6JGRecovery￿FTKXG￿KIPQTGU. 0QV￿￿CP[UWRRQTVGF￿XCNWG￿￿D[NCEGF￿VJG￿￿KPFTKXG￿VJKU￿￿HKGNF￿
		Post Error Recovery. When the value is 0, the drive returns a GOOD status
		in cases where error recovery is invoked and successful.
PER	0	When the value is 1, the drive returns a CHECK CONDITION status for re-
		covered errors, sets the sense key to	ECOVERED ERROR, and posts the
		appropriate additional sense key.
DTE	0	Disable Transfer on Error.
		Disable Correction. When the value is 0, ECC correction is applied as a
		means of recovering erred data. On write operations, a valid ECC is written
DCR	0	to each data sector regardless0QV￿ofUWRRQTVGFthe value￿D[in￿VJGthe￿FTKXGDCR￿bit.
		When the value is 1, ECC correction is disabled (but not retries or reads),
		and ECC errors cannot be corrected. However, on-the-fly is always enabled.
Read Retry	4	Specifies the number of retries attempted for a failed read operation.
Count
Correction(KGNF	&GHCWNV￿	Specifies the maximum number of bits in a data sector that the drive is al-
		lowed to correct. A value less than the default value can cause an otherwise
	8CNWG170	correctable error to be reported&GUETKVKQPas uncorrectable. If the initiator specifies a
Span		value larger than the default value, the drive automatically rounds down the
		number to the default value. A value of	causes the drive to use the default
		value. The drive ignores any value placed in this field.
Head Offset	0	Not supported by the drive.
Count
Data Strobe	0	Not supported by the drive.
Offset Count
Write Retry	8	Specifies the number of retries attempted for a failed write operation.
Count
		Specifies the maximum time, in milliseconds, that a retry is attempted on a
Recovery	0	failed sector during a read or write operation. When the value is 0, it means
Time Limit		that there is no time limit. The minimum permissible value, however, is 100
		milliseconds.

Maxtor Atlas 10K III 5-49