Minolta CF2002 manual When the Copier Is Not Operating Correctly

7.2 When the Copier Is Not Operating Correctly 7

7.2When the Copier Is Not Operating Correctly

Symptom	Possible Cause	Remedy
Nothing appears on the touch	If only the indicator on the	Press any key to cancel Energy
panel.	[Start] key is lit, the copier is in	Saver mode.
	Energy Saver mode.	(See section 1.5 in the Basic
		Operations volume.)
	The contrast control knob for	While looking at the touch
	the touch panel has been set	panel, adjust the contrast
	either too light or too dark.	control knob.
		(See section 1.6 in the Basic
		Operations volume.)
	The scanner power cord or the	Set the power switch for the
	interface cable are	copier to “O”, and then re-
	disconnected.	connect the scanner power
		cord and the interface cable.
The indicator on the [Start] key	An access code has not been	Enter your access code.
does not light up in green.	entered.	(See section 2.6 of the Basic
		Operations volume.)
Even though the [Start] key is	The copy/print job is queued for	Touch [Job Log] to check the
pressed, no copies are made	printing.	jobs that are queued. Wait until
		printing begins.
	The copier is still warming up	The copier takes about 5
	after just being turned on.	minutes to warm up after it is
		turned on.
		Wait until the copier has
		finished warming up.
	The copier is malfunctioning	Follow any messages that
		appear on the touch panel.
Keys on the control panel do not	If the indicator on the [Interrupt]	Press the Interrupt key to
respond.	key is lit, the copier is in	cancel the mode.
	Interrupt mode.	(See section 2.4 in the Basic
		Operations volume.)

The copier cannot be turned on.	The power supply cord may	Plug the power supply cord into
	have been unplugged from the	an electrical outlet.
	electrical outlet.
	The room’s circuit breaker was	Close the room’s circuit
	tripped.	breaker.

Troubleshooting Chapter 7

CF2002/CF3102 7-5