Utility Mode Operations Chapter 5
| 5 | 5.5 Administrator Mode Operations |
|
|
To set the “Stabilizer” function (if the image is still incorrect, even after the gradation levels have been adjusted)
If the image is incorrect, even after the gradation levels have been adjusted, set the “Stabilizer” function.
The following two modes are available with the “Stabilizer” function.
Reset And Stabilizer Mode
Stabilizer Mode
The “Stabilizer” function performs an image stabilization based on past data up to the previous session.
Image stabilization should normally be performed with “Stabilizer Mode” selected.
Select “Reset And Stabilizer Mode” only if the desired effect cannot be attained with the “Stabilizer Mode”.
1Press the [Utility] key.
2Touch [Admin. Mode].
3Using the keypad, enter the administrator access code.
4Touch [Expert Mode].
5Touch [Stabilizer].
6Press the [Start] key.
The indicator on the [Start] key changes to orange, and the image stabilization operation is performed.
The indicator on the [Start] key changes back to green.
The image stabilization procedure is finished.
CF2002/CF3102 |
