6.5 When the Message “Staple mode cannot be used.” Appears

6

 

To clear jammed staples in FN-8

When a finisher is installed and the staples are jammed, the message shown below appears.

Follow the procedure below to clear the jammed staples.

Note

If the message “Staple mode cannot be used.” appears, be sure to perform the following procedure.

If the paper is pulled out in any way other than that described below, the stapler unit may be damaged.

1Slide the finisher away from the

copier.

Touch Panel Messages Chapter 6

CF2002/CF3102

6-45

Page 160
Image 160
Minolta CF2002 manual To clear jammed staples in FN-8