Replacing basic chassis components Standard 1.10
114 CallPilot
Replacing a hard drive
Two hot-swappable SCSI drives are installed in your chassis. You do not
need to remove the chassis cover to add or replace a hot-swap hard drive,
but you must remove the front bezel to access the hard drives.

To replace a SCSI hard drive

1Remove the front bezel. Refer to “Removing and replacing the front
bezel” on page 106 for instructions.
2Attach the ESD strap to your wrist and attach the other end to a
known grounded connection.
3Locate the faulty hard drive. Refer to the following diagram of the
front panel.
ATTENTION The replacement hard drive must be the same size or larger
than the drive being replaced.