Nortel Networks 1005r manual Task List

Task List

To run the startup test	27
To run the POST	29
To determine why the server fails to boot to Windows	35
To determine why CallPilot fails to come into service	35
To use the operating system Event Viewer	43
To run the ipconfig command from Windows	47
To run the ping command from Windows	49
To run the tracert command from Windows	50
To run the arp command from Windows	52
To run the nbtstat command from Windows	54
To run the chkdsk utility from Windows	57
To investigate using the Alarm Monitor	64
To investigate using the Event Browser	66
To view the state of a hardware component	75
To start or stop a component	78
To run a diagnostic test	81
To view the last diagnostics result	83
To view or work with multimedia channel states	85
To view or work with call channel states	87
To access the Diagnostics Tool	91
To enable startup diagnostics	91
To disable startup diagnostics	91
To access the PEP Maintenance utility	93
To view a list of all installed PEPs	93
To access the session trace tool	94
To find a session	95
To access the CallPilot System Monitor	97
To remove the front bezel	104
To replace the front bezel	105
To remove the server cover	106
To replace the server cover	107
To remove the processor air duct	108
To replace the processor air duct	109
To hot-swap a power supply	110
To replace a SCSI hard drive	112
To replace the four-fan assembly	116
To replace a dual NIC card	119

1005r Server Maintenance and Diagnostics 9