Nortel Networks 1005r manual PCI riser assembly rear studs and slots

June 2007 Replacing or adding voice processing boards

18Line up the two grooves on the back lip of the PCI riser assembly with the pins on the rear panel as shown in the following illustration.

19Hold the PCI riser assembly by the two blue handles (A) and push the assembly into the server board. Refer to “PCI riser card assembly” on page 169.

ATTENTION
	If the PCI riser assembly is not fully seated, the server can
	malfunction.
Figure 50: PCI riser assembly rear studs and slots

20Reconnect the DS30X cable or cables to the MPB96 card or cards. You must reconnect each cable to the same MPB96 card it was previously connected to. Use the labels you applied as a guide.

21Replace the chassis cover.

22Take the ESD strap off.

23Power up the server and log on to Windows.

1005r Server Maintenance and Diagnostics 173