Replacing basic chassis components Standard 1.10
120 CallPilot
Replacing the dual NIC card
Your server has three low-profile PCI add-in cards. The RAID card is in
slot 1 and the two dual NIC cards are in slots 2 and 3 (counting from top
to bottom). The two dual NIC cards are reserved for future use.
PCI add-in cards are not hot-swappable and you must power down the
system before adding or replacing the cards.
.
CAUTION
Risk of electrical damage
Wear an antistatic ESD wrist strap when handling cards or
boards, or when working inside the server.
Do not touch the components or gold-edge connectors of
the cards.
Place the card on an antistatic surface until you are ready to
install it.
.
CAUTION
Risk of physical equipment damage
Remove the 1005r from the rack, and place it on a solid surface
when replacing or adding cards. The PCI riser assembly
requires considerable force when inserting it into the connector,
and physical damage can result if the assembly is not properly
aligned.
Placing the server on a solid surface such as a workbench gives
you a better view of the card alignment, and lets you exert the
necessary force when inserting the assembly into the connector.