Monitoring multimedia hardware Standard 1.10
78 CallPilot
Starting and stopping components
When you stop a component, you take it out of service and prevent it
from operating. You must stop a component before you can replace it (if
the component is replaceable) or run a diagnostic test on it.
To bring an out-of-service component back into service, you must start
it.
Start and stop components from the Maintenance section on the
Maintenance screen.
ATTENTION Nortel recommends that, if possible, you courtesy stop a
component. Courtesy stop is available at the individual
channel level.
To courtesy stop CallPilot, use the following:
Multimedia Monitor - to courtesy stop a range of
multimedia channels
Channel Monitor - to courtesy stop a range of call
(DS30X, also known as DS0) channels