Nortel Networks 1005r manual Replacing memory DIMMs, To replace the Dimm cards

Replacing basic chassis components Standard 1.10

Replacing memory DIMMs

Four Dual Inline Memory Modules (DIMMs) are installed on your server. You must replace all four memory DIMMs with those in the Nortel replacement pack. Nortel does not support more than four DIMM modules in the 1005r server.

CAUTION

Risk of equipment damage

Take precautions to protect internal components. Electrostatic discharge (ESD) can damage cards and make them unusable.

To replace the DIMM cards

1Power down the server, unplug all peripheral devices and Ethernet cables, and disconnect the AC power.

2Attach the ESD strap to your wrist and attach the other end to a known grounded connection.

3Remove the chassis cover. Refer to “Removing and replacing the server cover” on page 108 for instructions.

4Remove the processor air duct. Refer to “To remove the processor air duct” on page 110 for instruction.

5Locate memory banks 1A, 1B, 2A, and 2B on the server board. Refer to the following diagram.

132 CallPilot