Nortel Networks Modular ICS 4.0 manual Changing User Speed Dial

130 / User Preferences

Use the display buttons to change the programming for a button. User Preferences programming cannot change the buttons that are used by lines, intercom, and the handsfree feature.

The display buttons used in button programming.

CANCL Moves you out of a setting without making any changes to it.

CLR Erases the button.

TEL# Programs the key as an autodial number for an internal or an external number. If it is an external autodial number, you must choose a line, line pool, or the routing table for the call to use.

CHANGE

FEATR FIND

LIST

Used when you are setting up an external autodial number. Press CHANGE until you see the type of line or pool you want the number to use.

Press to store a feature code on the button.

Locates a specific button on a telephone by entering its number. Button numbers are shown in the illustrations.

Takes you to a list of feature codes. Press ‘to move through the list and press OK when you see the feature you want to program on the button.

Information about individual displays is described on page 132.

Changing User Speed Dial

1.Press ≠at User Speed Dial. The display shows the number of speed dial codes that are available.

2.Press ‘to see the first speed dial code (71).

3.Press ‘to move through all the speed dial codes.

4.Press ≠at the code you want to change.

5.Press CHANGE and enter the telephone number the same way you would dial it on the telephone.

6.Press OK.

Modular ICS 4.0 System Coordinator Guide P0881591 Issue 01