Nortel Networks NN43001-301 manual Procedure Enabling the NTAK09 DTI/PRI card

Install PRI hardware 211

—End—

Procedure 32

Enabling the NTAK09 DTI/PRI card

Step Action

The DCHI and PRI cards must be configured prior to software enabling the NTAK09. Refer to the procedure Procedure 33 "Implementing basic PRI" (page 212) for further information.

1Enter the following command in LD 60 to software enable all NTAK09 DTI/PRI cards:

ENLL C

where C is the DTI/PRI card number (DLOP). The card number associated with a DTI/PRI card is based on the slot in which the card is installed.

Under normal conditions, this step enables the clock controller and D-channel interface. If enable fails, enter the following command in LD 60 to software enable clock tracking on the primary digital card:

ENL CC 0

2Enter the following command in LD 96 to software enable the NTAK93 (DCHI) daughterboard:

ENL DCHI N

where N is the DCHI I/O address.

3Within about 30 seconds, the D-channel layer 3 should be established. To confirm, enter the following command in LD 60 to request the current status of the D-channel:

STAT DCH (N)

The system response is:

DCH N EST OPER

This means that the D-channel is established and operational.

—End—

Use this procedure to configure the PRI cards, DCHI interface, DCH link and ISDN trunk route and trunks (B-channels) that are required to implement PRI between systems. No feature applications other than Basic Call Service are included in the implementation.

Nortel Communication Server 1000

ISDN Primary Rate Interface Installation and Commissioning

NN43001-301 02.03 Standard

Release 5.5 7 December 2007

Copyright © 2003-2007, Nortel Networks