Nortel Networks NN43001-301 manual Ato, Xut, Xem

2482.0 Mb DTI implementation

Prompt	Response		Description
ONP	r	t	On-premises extension.
OPX	r	t	Off-premises extension.
TNLS	YES (NO)		TN List. This is for the print command only.
			A YES response means that a list of the trunk TNs using the
			requested PAD category tables are printed after the table.
DFLT	(1)-16		For NEW only. The table is used for default values.

The following prompts define the pad levels.

The receiving pad code is r and the transmission pad code is t. These entries have the range 0-15. The pad values (in decibels) relating to these codes are shown after this table.

ONP	r	t	On-premises extension.
OPX	r	t	Off-premises extension.
DTT	r	t	Digital TIE trunks.
SDTT	r	t	Digital Satellite TIE trunks.
NTC	r	t	Nontransmission compensated.
TRC	r	t	Transmission compensated.
DCO	r	t	digital COT, FEX, WAT, and DID trunks.
VNL	r	t	Via Net Loss.
DTO	r	t	2.0 Mb DTI digital TOLL office trunks.
ACO	r	t	Analog CO or WATS trunks.
AFX	r	t	Analog FEX trunks.
ADD	r	t	Analog DID trunks.
SATT	r	t	Analog satellite TIE trunks.
ATO	r	t	Analog TOLL office trunks.
DTI2	r	t	2.0 Mb DTI trunk
			(Prompted only if the 1.5/2.0 Mb Gateway feature is equipped
			and TYPE=DTI2).
XUT	r	t	Analog CO trunk
			(Prompted only if the 1.5/2.0 Mb Gateway feature is equipped
			and TYPE=DTI2).
XEM	r	t	Analog TIE trunk
			(Prompted only if the 1.5/2.0 Mb Gateway feature is equipped
			and TYPE=DTI2).

The following pads are available for the 2.0 Mb DTI card. Their respective codes are also given. Positive dB represents loss and negative dB represents gain.

Nortel Communication Server 1000

ISDN Primary Rate Interface Installation and Commissioning

NN43001-301 02.03 Standard

Release 5.5 7 December 2007

Copyright © 2003-2007, Nortel Networks