Nortel Networks NN43001-301 Software enable the DTI/PRI cards, Procedure Enabling the NTAK09 card

2221.5 Mb DTI implementation

Software enable the DTI/PRI cards

Procedure 34

Enabling the NTRB21 TMDI card

Step Action

1Enter the following command in LD 96 to enable the NTRB21 TMDI card:

ENL TMDI x ALL

where

xis the NTRB21 TMDI card number (DLOP). The card number associated with a NTRB21 TMDI card is based on the slot in which the card is installed.

2If in DTI mode, enter the following command in LD 96 to software enable the D-channel:

ENL DCH y

where

yis the DCH port number that was assigned in LD 17.

3Within about 30 seconds, the D-channel layer 3 should be established. To confirm, enter the following command in LD 60 to request the current status of the D-channel:

STAT DCH (N)

The system response is:

DCH N EST OPER

This means that the D-channel is established and operational.

—End—

The DCHI and DTI cards must be implemented prior to software enabling the NTAK09. Refer to the section Procedure 33 "Implementing basic PRI" (page 212) for further information.

Procedure 35

Enabling the NTAK09 card

Step Action

1Enter the following command in LD 60 to software enable all NTAK09 DTI/PRI cards:

Nortel Communication Server 1000

ISDN Primary Rate Interface Installation and Commissioning

NN43001-301 02.03 Standard

Release 5.5 7 December 2007

Copyright © 2003-2007, Nortel Networks