Nortel Networks NN43001-301 manual LD 73 Defining the 2.0 Mb DTI system timers

2522.0 Mb DTI implementation

Prompt	Response	Description
GP2	T2 mt dt ct ot	Group 2 error thresholds.
		This is the maximum amount of time that can occur before
		software checks the associated thresholds of 120 to 32640
		msec and rounds it to the closest multiple of 128 msec. T2 error
		count values are in the range 1-(20)-255. NC = Error count
		values are in the range 1-255.
		mt = Maintenance threshold time (MNT).
		dt = No new data calls threshold time (NNDC).
		ct = No new calls threshold time (NNC).
		ot = Out of service threshold time (OOS).
		Note: The following requirements must be met for this input: mt
		= >dt = >ct = >ot.
FRFW	YES (NO)	This 2.0 Mb DTI card is (is not) equipped with special Firmware
		for France.
LD 73 - Defining the 2.0 Mb DTI system timers
Prompt	Response	Description
REQ	NEW	Add or Change Digital Trunk Interface data block.
	CHG
TYPE	DTI2	2.0 Mb DTI.
FEAT	SYTI	Change the switch timers and counters for 2.0 Mb DTI.
		There is only one such block per switch.
MAND	0-(15)-1440	Maintenance guard time in minutes.
NCSD	0-(15)-1440	New call suppression guard time in minutes and seconds.
	1S-59S
OSGD	0-(15)-1440	Out-of-service guard time in minutes.
OOSC	0-(5)-127	Out-of-service occurrences since midnight (DTI disabled).
PERS	0-(100)-254	Persistence timer in milliseconds for far-end problems.
DBNC	(10)-32	Debounce timer in milliseconds.
CCO	xx	Card slot number for Clock Controller 0.
	<CR>	No change for defaults.
	X	To remove clock controller data.
PREF CCO	xx	Card number of PRI/DTI/SILC containing the primary clock
		reference for the main cabinet
SREF CCO	xx	Card number of PRI/DTI/SILC containing the primary clock
		reference for the main cabinet
CC1	xx	Card number for Clock Controller 1.

Nortel Communication Server 1000

ISDN Primary Rate Interface Installation and Commissioning

NN43001-301 02.03 Standard

Release 5.5 7 December 2007

Copyright © 2003-2007, Nortel Networks