Nortel Networks NN43001-301 manual Configuring basic ISL capability Step Action

ISL software implementation 289

Dedicated mode

The DCHI uses the NTAK02 circuit card and does not support ISDN PRI signaling. The DCHI is reserved for ISL use only. The D-channel can communicate with the far-end by means of a dedicated leased line modem or dialup modem.

Note that the following implementation relates to analogue TIE trunks being used as B-channels. In the case where DTI/PRI trunks are also used, then LD 17 digital loop (2.0 Mb PRI) and LD73 (2.0 Mb PRI/SYTI) must also be configured with the appropriate clocking and threshold settings.

For ISL dedicated mode using a dialup modem, a 500 set, TIE trunk route and member must be programmed (used for D-channel). Table 106 "Configuring basic ISL capability" (page 289) summarizes the required steps.

Table 106

Configuring basic ISL capability

Step	LD	Action
1	17	Configure the D-channel for ISL use.
2	15	Enable ISDN option.
3	16	Enable the ISL option on a per route basis, assign a D-channel
		for each route.
4	14	Assign a channel identification to each trunk with the ISL
		option.

LD 17 - Configure the D-channel for ISL

Prompt	Response	Description
REQ	CHG	Change existing data
TYPE	CFN	Configuration data block.
ADAN	NEW DCH 0-79	Add primary D-channel.
CTYP	DCHI	D-channel card type.
CDNO	0-15	Serial Data Interface (SDI) Card number.
		Number the SDI cards logically with the
	1-9 11-19 21-29,	system.
	31-39 41-49
		MSDL application small system Card
	1-50	number
		DCHI small system Card number
PORT	1	Must be set to 1.

Nortel Communication Server 1000

ISDN Primary Rate Interface Installation and Commissioning

NN43001-301 02.03 Standard

Release 5.5 7 December 2007

Copyright © 2003-2007, Nortel Networks