Nortel Networks NN43001-301 manual Type Adan, Ctyp Dchi, Cdno, Port, Des, Usr Pri, Ifc, Otbf, Drat

		Install PRI hardware 213
LD 17 - Adding a D-channel interface
Prompt	Response	Description
REQ	CHG	Change existing data.
TYPE	ADAN	Action Device And Number.
- ADAN	NEW DCH xx	Add a primary D-channel (any unused SDI port.)
	CHG DCH xx	Change a primary D-channel.
	OUT DCH xx	Remove the primary D-channel, where:
		xx =0-79.
- CTYP	DCHI	DCHI = D-channel configuration for the NTAK09 card or
		NTAK93.
	MSDL
		MSDL = NTBK51 Downloadable D-channel daughterboard.
	TMDI
		TMDI = D-channel configuration on TMDI (NTRB21) card.
- CDNO	1-50	Card slot number to be used as the primary DDCH/DCHI.
		Card slots 10, 20, 30, 40, and 50 are only applicable for
		D-channel configuration of ISL or VNS.
- PORT	1	PORT must be set to 1.
- DES	<CR>	Designator.
- USR	PRI	D-channel is for ISDN PRI only.
- IFC	xx	Interface type.
- - DCHL	xx	PRI loop number.
- OTBF	1-(16)-127	Number of output request buffers.
		Note: For a single PRI link, leave this prompt at default (16).
		Add 5 output request buffers per additional link.
- DRAT	64KC	D-channel transmission rate.
- SIDE	NET (USR)	Prompted only if IFC is set to SL1.
		NET = network, the controlling switch.
		USR = slave to the controller.

-RLS

-RCAP

-OVLR

xx

ND2

YES (NO)

Release ID of the switch at the far-end of the D-channel.

Remote capability.

Allow or disallow overlap receiving on a D-channel. Default is NO. Enter carriage return if settings are to be left at default.

Nortel Communication Server 1000

ISDN Primary Rate Interface Installation and Commissioning

NN43001-301 02.03 Standard

Release 5.5 7 December 2007

Copyright © 2003-2007, Nortel Networks