Nortel Networks NN43001-301 manual Enll C, Procedure Implementing DTI

Software enable the DTI/PRI cards 223

ENLL C

where

Cis the DTI/PRI card number (DLOP). The card number associated with a DTI/PRI card is based on the slot in which the card is installed.

Under normal conditions, this step enables the clock controller and D-channel interface. If enable fails, go to step 2.

2Optional: Enter the following command in LD 60 to enable clock tracking on the primary digital card:

ENL CC 0

3Enter the following command in LD 96 to software enable the NTAK93 (DCHI) daughterboard:

ENL DCHI N

where

Nis the DCHI I/O address.

4Within about 30 seconds, the D-channel layer 3 should be established. To confirm, enter the following command in LD 60 to request the current status of the D-channel:

STAT DCH (N)

The system response is:

DCH N EST OPER

This means that the D-channel is established and operational.

—End—

Use this procedure to implement the DTI software interface between systems or between a system and a central office.

Procedure 36

Implementing DTI

Step Action

1Add a DTI card. See "LD 17 - Adding a DTI card" (page 224).

2Configure a DTI trunk route. See "LD 16 - Configuring a DTI trunk route" (page 224).

3Configure the trunks. See "LD 14 - Configuring the trunks" (page 225).

Nortel Communication Server 1000

ISDN Primary Rate Interface Installation and Commissioning

NN43001-301 02.03 Standard

Release 5.5 7 December 2007

Copyright © 2003-2007, Nortel Networks