Nortel Networks NN43001-301 manual Procedure Implementing basic PRI

2121.5 Mb PRI implementation

PRI cards must be configured before defining the DCH links or PRI applications.

Prompts which do not show a response can be left as default. For more information on any of these prompts, refer to Software Input Output Administration (NN43001-611).

Before installing PRI cards in an IP expansion cabinet/Media Gateway, first configure the expansion cabinet/Media Gateway for IP connectivity. Refer to LD 117 in the Software Input Output Reference — Maintenance (NN43001-711)for further information.

To implement PRI on the system:

Procedure 33

Implementing basic PRI

Step Action

1Add a PRI card. step 6

2Add a DCHI card. "LD 17 - Adding a PRI card" (page 212)

3Define a PRI customer. "LD 15 - Defining a PRI customer" (page 214)

4Define a PRI service route. "LD 16 - Configuring an ISDN service route" (page 215)

5Define service channels (B-channels) and PRI trunks. "LD 14 - Defining service channels and PRI trunks" (page 216)

6Define clock synchronization. "LD 73 - Defining system timers and clock controller parameters" (page 217)

		—End—
LD 17 - Adding a PRI card
Prompt	Response	Description
REQ	CHG	Change existing data.
TYPE	CFN	Configuration data block.
CEQU	YES	Changes to common equipment.
PRI	loop x card x	For Large Systems and Small Systems
TMDI	(Yes)	TMDI Card (Mode set to PRI OR TRK) Option 11C Cabinet Other card
	No

Nortel Communication Server 1000

ISDN Primary Rate Interface Installation and Commissioning

NN43001-301 02.03 Standard

Release 5.5 7 December 2007

Copyright © 2003-2007, Nortel Networks