Nortel Networks NN43001-301 Port addressing modes Port 0 Mode selection, Port 1 mode selection

Set up the NT6D11AB, NT6D11AE, NT6D11AF DCHI 83

Figure 37

NT6D11 DCH with ISL low-speed programming jumper settings

Port addressing modes

Port 0 Mode selection

Port 0 is used to select whether the asynchronous ESDI port is be disabled or not. Refer to Table 24 "Port 0 mode selection" (page 83).

Note: The asynchronous ESDI port must be set to "disabled".

Table 24

Port 0 mode selection

Port Mode		Switch Setting
	SW1.1		SW1.2
Not used	0		-
Asynchronous ESDI	1		0
Port disabled	1		1

Port 1 mode selection

Port 1 is used to select the standard or expanded D-channel addressing mode on the NT6D11AB/AE/AF. Refer to Table 25 "Port 1 mode selection" (page 84).

Nortel Communication Server 1000

ISDN Primary Rate Interface Installation and Commissioning

NN43001-301 02.03 Standard

Release 5.5 7 December 2007

Copyright © 2003-2007, Nortel Networks