Nortel Networks NN43001-301 manual Ccgd, CHG Type RDB

		DTI software implementation 253
Prompt	Response	Description
PREF CC1	xx	Primary Reference DTI/PRI loop for Clock controller one.
SREF CC1	xx	Primary Reference DTI/PRI loop for Clock controller one.
CC2	xx	Card number for Clock Controller 2.
PREF CC2	xx	Card number of PRI/DTI/SILC or DTI2/PRI2/SILC containing the
		primary clock reference.
SREF CC2	xx	Card number of PRI/DTI/SILC or DTI2/PRI2/SILC containing the
		primary clock reference.
CC3	xx	Card number for Clock Controller 3.
PREF CC3	xx	Card number of PRI/DTI/SILC or DTI2/PRI2/SILC containing the
		primary clock reference.
SREF CC3	xx	Card number of PRI/DTI/SILC or DTI2/PRI2/SILC containing the
		primary clock reference.
CC4	xx	Card number for Clock Controller 4.
PREF CC4	xx	Card number of PRI/DTI/SILC or DTI2/PRI2/SILC containing the
		primary clock reference.
CCGD	0-(15)-1440	Clock controller free run guard time in minutes.
CCAR	0-(15)	Clock controller audit rate. The time, in minutes, between normal
		CC audits. Only programmable on units equipped with 2-Mb DTI.
		Note 1: The clock controller prompts only appear for clocks
		which are valid for the machine type being configured. The
		prompts only appear if the system is in a valid state for the
		definition of the 2.0 Mb DTI clock controller data that is, the DTI
		clock references must be unused or in a free-run mode.
		Note 2: Before programming clock controller references, the
		QPC775 clock controller card(s) must be plugged in, and the
		switches on the system’s QPC441 3 Port Extender must be
		appropriately set. Otherwise, the PREF and SREF prompts are
		not given.

LD 16 - Configuring the service routes

Prompt	Response	Description
REQ	NEW	Add or Change Route data block.
	CHG
TYPE	RDB	Route data block.
CUST	xx	Customer number, as defined in LD 15

Nortel Communication Server 1000

ISDN Primary Rate Interface Installation and Commissioning

NN43001-301 02.03 Standard

Release 5.5 7 December 2007

Copyright © 2003-2007, Nortel Networks