Nortel Networks NN43001-301 manual Rout, Tktp TIE, Dtrk YES/NO, Mode Isld

		Basic ISL implementation 235
Prompt	Response	Description
AC2		Access Code 2. Enter call types (type of number) that use
		access code 2. Multiple responses are permitted. This
		prompt only appears on NARS equipped systems. If a call
		type is not entered here, it is automatically defaulted to
		access code 1.
	NPA	E.164 National.
	NXX	E.164 Subscriber.
	INTL	International.
	SPN	Special Number.
	LOC	Location Code.
LD 16 - Enabling ISL option on a per-route basis, assigning a D-channel for each route
Prompt	Response	Description
REQ	NEW CHG	Add new data. Change existing data.
TYPE	RDB	Route data block.
CUST	xx	Customer number as defined in LD 15.
ROUT	0-511	Route number Range for Large System and CS 1000E
		system.
	0-127	Range for Meridian 1 Small System, Media Gateway 1000B
TKTP	TIE	TIE Trunk route.
DTRK	YES/NO	Enter YES if this is a Digital Trunk Interface (DTI or PRI).
ISDN	YES	ISDN option.
MODE	ISLD	Route for ISL application.
DCHI	XX	DCHI port number in CFN which carries the D-channel for
		this TIE Trunk route.
PNI	1-32700	Customer private network identifier. Must be the same as
		the CDB PNI at the far-end.
IFC		Interface type.
	SL1	Interface type
CTYP	<CR>	Call Type. Enter the call type to be associated with the
		outgoing route for direct dialing using the trunk access code
		(instead of NARS access code). See the Software Input
		Output Reference — System Messages (NN43001-712)
		for a list of valid responses.
INAC	YES	Insert Access Code. Permits the NARS AC1 or AC2
		access code to be reinserted automatically on an incoming
		ESN call.

Nortel Communication Server 1000

ISDN Primary Rate Interface Installation and Commissioning

NN43001-301 02.03 Standard

Release 5.5 7 December 2007

Copyright © 2003-2007, Nortel Networks