Nortel Networks NN43001-301 manual Task summary list, Incoming/Outgoing Calls, Incoming Calls

2422.0 Mb DTI implementation

Task summary list

The following is a summary of the tasks in this section:

1."LD 17 - Adding a 2.0 Mb DTI card" (page 242)

2."LD 73 - Defining the 2.0 Mb DTI ABCD signaling bit tables" (page 242)

3."LD 73 - Defining the 2.0 Mb DTI pad tables" (page 246)

4."LD 73 - Defining the 2.0 Mb DTI timers" (page 249)

5."LD 73 - Defining the 2.0 Mb DTI system timers" (page 252)

6."LD 16 - Configuring the service routes" (page 253)

LD 17 - Adding a 2.0 Mb DTI card

Prompt	Response	Description
REQ	CHG	Change.
TYPE	CEQU	Common equipment.
...
DTI2	xx	Enter a card slot number for 2.0 Mb DTI.
LD 73 - Defining the 2.0 Mb DTI ABCD signaling bit tables
Prompt	Response	Description
REQ	NEW	Add or change Digital Trunk Interface data block.
	CHG
TYPE	DTI2	2.0 Mb/s DTI data block.
FEAT	ABCD	ABCD bit signaling category.
SICA	2-16	Signaling category.
...
DFLT	(1)-16	Default signaling category used for default values
		JDMI defaults to 16 with <CR>3.
Incoming/Outgoing Calls:
IDLE(S)	abcd	(Send) idle signal bits.
IDLE(R)	abcd	(Receive) idle signal bits.
FALT(S)	abcd	(Send) bits. 2.0 Mb DTI out-of-service.
	N	If FALT (send) signal not required.
FALT(R)	abcd	(Receive) bits. 2.0 Mb DTI out-of-service.
	N	If FALT (receive) signal not required.
Incoming Calls:

Nortel Communication Server 1000

ISDN Primary Rate Interface Installation and Commissioning

NN43001-301 02.03 Standard

Release 5.5 7 December 2007

Copyright © 2003-2007, Nortel Networks