17 REMOTE RECEIVE
This function lets you use an attached phone to tell your fax machine to switch from telephone to fax mode so it can receive an incoming fax. Use the keypad of an external telephone to enter the remote receive number you have programmed into your fax machine.
In addition, if your fax machine is in TAD mode, a caller can enter the programmed remote receive number after leaving a voice message; this enables the fax machine to receive a fax from the caller. Refer to the “Answering Mode, Using Your Fax with an Answering Machine [TAD]” section of this handbook.
Available settings are OFF (default), 00, 11, 22, 33, 44, 55, 66, 77, 88, 99, **, and ##.
18 MEM./FEEDER SW.
The fax unit is set to scan documents in and transmit them from memory. This function controls how manual feed transmissions are performed. Available settings are FEEDER (the default setting) and MEMORY.
To perform a manual feed transmission with FEEDER selected:
1Load document.
2Press Select Function
3 | Press BROADCAST FEEDER TX |
| The display shows |
| FEEDER TX |
| YES(LOC.) NO( ) |
4 | Enter the location, then press START. |
1 | Load document. |
| ´ |
|
2 | Press Select Function. |
| ||
3 | Press BROADCAST |
| FEEDER TX | |
| The display showsÆ |
|
| |
| BROADCAST/MEMORY TX | |||
| YES(LOC./#) | NO( | ) | |
4 | Enter the list of locations, then press START. | |||
19 NOT USED |
| ´Æ | Handbook 47 |
If you do a lot of broadcast transmissions, change this setting to MEMORY.
To perform a broadcast transmission with MEMORY selected: