Packard Bell MH4000 manual Removing Side Rails, Removing side rails from blank panel tray

5-47

Figure 5-20. Removing Side Rails

C

Removing side rails from blank panel tray

A Screws

B Side rails

C Blank panel tray

B

A

12.Set any device jumpers or switches on the device. Refer to the installation procedures that came with the device.

Notice: SCSI termination resistors for the 5 1/4-inch devices must be installed in the last SCSI device of the daisy chain cabling (top media bay A). All other 5 1/4- inch devices must have terminators removed.

13.Using the four screws supplied with the drive, reinstall the side rails just removed from the blank panel tray (Figure 5-21, A). Attach the rails to each side of the device (C) by using only the bottom screw holes, as shown. The rails for each side of the device are identical.

14.Engage the device side rails into the bay guide rails (see Figure 5-22). Ensure that the device side rails (see Figure 5-22, A) are inside the bay guide rails exactly as shown in Figure 5-22, B.

15.Push the drive into the bay until the screw holes of the side rails are directly in front of the chassis screw holes and secure with the screws previously removed (see Figure 5-21, C).

Upgrades and Options