Installing a Power Supply Module

5-37

1.Before installing the power supply module pull the release-handle down.

2.Slide the new or replacement power supply module into the chassis until the power supply module release-handle is almost closed (upright position).

3.Push the power supply module release-handle up and in until the power supply module slides in further and locks in place.

4.If removed, connect the AC power cord to the back of the power supply cage.

5.If OFF, set the main AC power switch to its ON position. The main AC power switch is located at the top of the power supply cage.

Packard Bell MH4000 manual Installing a Power Supply Module