Installing Video Memory
Notice: Observe static precautions. Use an antistatic wrist strap.
1.If the system is on, power off the system and remove the left side panel as described earlier in this chapter.
2.To gain access to the video sockets, remove the memory board, refer to Removing the Memory Board earlier in this chapter.
3.Align the beveled edge of the video memory module with the notched corner of the video memory socket. Refer to Figure
4.Press the video memory module down firmly until it is fully seated in its socket.
5.Reinstall the memory board that was removed in step2, refer to Installing the Memory Board earlier in this chapter.
6.Replace the side panel and power on the system.
Non - Volatile Memory
You may need to replace the
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with same or equivalent type recommended by manufacturer. Dispose of lithium batteries as required by local ordinance or as normal waste if no local ordinance exists. Do not expose the component to excessive heat or fire. Keep all batteries away from children.
