Packard Bell MH4000 manual Removing a 5 1/4-Inch Device or 3 1/2-Inch Diskette Drive

5-50

18.Reinstall the front plastic cover, top cover, the side cover, and power on the system. It may be necessary to run the SCU as described in the Configuring Your System chapter.

Removing a 5 1/4-Inch Device or 3 1/2-Inch Diskette Drive

1.Power off the system and remove the left side panel (as viewed from front) as described earlier in this chapter.

2.Remove the front plastic cover, refer to Installing a 5 1/4-Inch Device or 3 1/2-Inch Diskette Drive as described earlier in this chapter.

3.Observe the safety and ESD precautions listed at the beginning of this chapter.

4.Remove the two screws that secure the device side rails to the front of the chassis.

5.Disconnect the signal and power cables from the back of the drive.

6.Slide drive out the front of the bay, and place on an antistatic surface.

7.Remove and save the side rails and screws.

8.Place drive in an antistatic wrapper.

9.To cover an empty bay, install a blank panel tray in the bay.(Figure 5-24).

10.Attached the side rails and screws just saved to a reusable blank panel tray previously removed.

11.Engage the blank panel tray side rails into the bay guide rails (see Figure 5-22). Ensure that the blank panel tray side rails (see Figure 5-22, A) are inside the bay guide rails (see Figure 5-22, B).

Upgrades and Options