Floppy Disk Drive Activity LED Does Not Light
Check the following:
■Are the floppy disk drive power and signal cables properly installed?
■Are all relevant switches and jumpers on the floppy disk drive set correctly?
■Is the floppy disk drive properly configured in Setup?
If you are using the onboard floppy disk controller, use Setup or the SCU to make sure that Onboard Floppy is set to Enabled. Conversely, to use an optional fixed/floppy disk controller, make sure that Onboard Floppy is set to Disabled. For information about running Setup or the SCU, refer to the Configuring Your System chapter.
If the problem persists, there may be a problem with the floppy disk drive, system board, or drive signal cable. Contact your service representative for assistance.
